ACM MATIX Serie Instructions D'utilisation page 14

FIG.4
FIG.5
Brown Black
ADJUSTING THE MATIX Ø35- Ø45-Ø55 LIMIT SWITCH
Figure 6 illustrates that whatever the type of installation (right or left), screw "A" regulates the downward movement
and screw "B" the upward movement. Move the rolling shutter (or awning) down by pressing the button. If the rolling
shutter does not reach the position required, turn screw "A" clockwise and with the button pressed down, bring the
rolling shutter down to the position required. If, instead, the rolling shutter stops below the position required move it
back up using the control button and then turn screw "A" in a anticlockwise direction to reduce the travelling distance
so that even if the button is pressed the rolling shutter remains stationary.At this point repeat the operations described
for the top position of the rolling shutter. Press the button to wind the rolling shutter up. If the stop position of the
rolling shutter is too low turn screw "B" clockwise until it reaches the position required. If the rolling shutter stops in a
position that is too high,turn screw "B" anticlockwise to reduce the travelling distance.
E – English
PREDISPOSITION OF THE QUICK MOUNTING BRACKET
A) Fix the wall bracket;
B) Attach the spring in the groove of the motor head;
C) Hook the motor head in the seat bracket.
WIRING
Blue Yellow/Green Phase Neutral Earth Switch
120V~ 60Hz
Omnipolar device