Table des Matières
Publicité
disclaimers
the mattress support platform shall be ± 3°, which translates to a tolerance of up to 1
½".
The angle (designated "B" in figure 1) between the flat section and foot section for
various configurations of the mattress support platform shall be ± 3°, which translates
to a tolerance of up to ¾".
Any adjustable foundation deemed to be within these allocated tolerances is
considered to have met the manufacturer's quality control standards.
THAT "NEW PRODUCT" SMELL:
Some people notice a slight odor to their new adjustable base—this can come from our
material manufacturing process. This smell is normal and usually disappears before the
product reaches you. Sometimes, however, this smell may still be noticeable. It usually
disappears after a few weeks, providing adequate ventilation of the product and the
environment.
BREAK IN PERIOD:
You can speed up the break-in period by simply spending time in the adjustable bed
through activities such as reading, watching TV or playing with the kids or grandkids.
The extra movement will help the adjustable base respond to weight and temperature
changes. Some of the materials in our adjustable bases such as the woods, metals and
plastics used in the platform, frame and components are sensitive to moisture content
and temperature and may make sounds in colder environments.
PAIRED OPERATION:
When operating a "paired" split base setup there may be a time latency up to 1.5
seconds between each bases articulation.
WEAR AND TEAR:
Wear and tear is damage that naturally and inevitably occurs as a result of normal use
or aging.
FABRIC CARE:
To prolong the life of your fabric, protect from direct sunlight whenever possible.
For spot cleaning, wipe area with a light damp sponge or vacuum with a soft brush
attachment to remove particles. Keep at a minimum of 30cm (12 inches) away from
direct heat sources. For a deeper cleaning, blot liquid spills with a clean dry cloth. Wipe
with a clean cloth dampened with warm water. Do not wet excessively. A soft bristle
brush may be used to remove ingrained soil. Avoid scratching by gentle brushing. Wipe
with a clean cloth dampened with warm water to remove residues. Dry in shade away
from direct heat. If persistent marks remain visible after cleaning, seek professional
advice.
PRODUCT RATINGS:
The lift motors are not designed to operate continuously for more than [2] minutes in
an [18] minute time period or approximately 10% duty cycle. Attempting to circumvent
or exceed this rating will shorten the life expectancy of the product and may void the
warranty. The massage motors are not designed to operate continuously for more than
30 minutes at a time. Please allow the massaging system to rest for 30 minutes after
automatic massage shut off before restarting.
WEIGHT LIMITS:
This product is not rated to support weights exceeding 850 pounds. This product is
not rated to support weights in excess of 850 pounds inclusive of the mattress and
bedding. The base will structurally support this weight, provided it is evenly distributed
across the bed base. The adjustable base is not designed to support or lift this amount
in the head or foot sections alone. Exceeding this weight restriction could damage the
bed and/or cause injury and will void the warranty.
IMPORTANT DO'S AND DON'TS
DO:
•
Plug your adjustable base into a power surge protector.
•
Evenly distribute weight when sleeping in a split setup. Uneven distribution of
weight can cause the base to raise unevenly.
•
Call Customer Service for any technical issues. Do not try to force the base down,
this can damage the motors or frame.
•
Use mild soap and water to clean your adjustable base if staining occurs.
•
Keep in mind that adjustable bases are recommended to be used with adjustable
friendly mattresses
•
Lower to the flat (horizontal) position after use and in between presets.
•
Register your warranty as soon as your adjustable base has been delivered.
DON'T
2
•
Sit on corners/edges of base, this may warp the frame, struts or foam.
•
Tilt the base on its side. This can damage the legs and/or leg screws.
•
Stand or jump on the adjustable base at any time, this can damage the frame and
motors.
•
Drag the base to move it. Dragging the base could damage the frame, strip the
nut/bolts or break the legs. Purchase castors if you plan on moving your base
routinely.
•
Enter and exit the adjustable base with the head and/or foot in the articulated
position. Enter or exit your adjustable in the flat (horizontal) position.
•
Tinker with or modify base. This will void the warranty.
•
Press down on the head or foot while actuated can damage frame and motors.
FCC Compliance:
This device complies with part 15 of the FCC Rules. Operation
is subject to the following two conditions: (1) This device
may not cause harmful interference, and (2) this device must
accept any interference received, including interference that
may cause undesired operation.
To comply with the FCC RF exposure requirements, no change
to the antenna or the device is permitted. Any change to the
antenna or the device could result in the device exceeding the
RF exposure requirement and void user's right to operate the
device.
Radio Frequency: 2.4 GHz
Publicité
Table des Matières
