CamOneTec FCHD91 Mode D'emploi page 13

www.CamOneTec.com
Connection
The supplied Video-In cables support various camera systems (video-sources).
1x Video-In USB-Cable for CamOne cameras
1x Video-In USB-Cable for GoPro cameras
Please take the matching cable and and connect the plug „BEC male" into the AV BEC-socket
(female).
(!!Check the polarity!!)
Please note that damages resulting from improper use or connection of an unsuitable power source
are not covered by the warranty.
Carry out the work carefully and only if you are familiar with the technology and are aware of the
hazards involved. Make sure that the power source used has sufficient capacity!
Channel-/ Bandsetting
Please set your channel and video band by using the switches shown below.
The micro switch #6 has no function.
Make sure that your receiver module is working on the same channels and bands.
Perform this setting when the transmitter is switched off and use non-electrical tools only!
13