General Power Tool Safety Warnings - Makita LC1230 Manuel D'instructions

ENGLISH
(Original instructions)
1 Hook
2 Bolt
3 Lock-off button
4 Lever
5 Switch trigger
6 Graduation
7 Indicator
8 Vise stop
9 Dust box
SPECIFICATIONS
Model
Blade diameter ................................................................................................................................................... 305 mm
Hole (arbor) diameter ........................................................................................................................................ 25.4 mm
Max. kerf thickness of the saw blade.................................................................................................................... 2.5 mm
No load speed ............................................................................................................................................... 1,700 min
Dimensions (L x W x H) ...................................................................................................... 516 mm x 306 mm x 603 mm
Net weight ............................................................................................................................................................19.2 kg
Safety class ..............................................................................................................................................................
• Due to our continuing program of research and development, the specifications herein are subject to change without
notice.
• Specifications may differ from country to country.
• Weight according to EPTA-Procedure 01/2014
Cutting capacity
Workpiece shape
Cutting angle
90°
45°
Intended use
The tool is intended for cutting in mild steel and stainless
steel with appropriate saw blades.
Power supply
The tool should be connected only to a power supply of
the same voltage as indicated on the nameplate, and can
only be operated on single-phase AC supply. They are
double-insulated and can, therefore, also be used from
sockets without earth wire.
For public low-voltage distribution systems of
between 220 V and 250 V
Switching operations of electric apparatus cause voltage
fluctuations. The operation of this device under unfavor-
able mains conditions can have adverse effects to the
operation of other equipment. With a mains impedance
equal or less than 0.25 Ohms it can be presumed that
there will be no negative effects. The mains socket used
for this device must be protected with a fuse or protective
circuit breaker having slow tripping characteristics.
8
Explanation of general view
10 Wrench holder
11 Base
12 Center cover
13 Hex bolt
14 Socket wrench
15 Blade guard
16 Shaft lock
17 Carbide-tipped saw blade
18 Spindle
115 mm
90 mm
ENE008-1 SAFETY WARNINGS

General power tool safety warnings

ENF002-2
illustrations and specifications provided with this
power tool. Failure to follow all instructions listed below
may result in electric shock, fire and/or serious injury.
Save all warnings and instructions for future
reference.
The term "power tool" in the warnings refers to your
mains-operated (corded) power tool or battery-operated
ENF100-1
(cordless) power tool.
19 Inner flange
20 Outer flange
21 Vise plate
22 Vise nut
23 Vise handle
24 Limit mark
25 Screwdriver
26 Brush holder cap
A
WARNING Read all safety warnings, instructions,
LC1230
75 mm x 150 mm
100 mm x 100 mm
85 mm x 85 mm
GEA010-2
–1
/II