Reese 26002 Instructions D'installation page 5

11. Install ½-13 x 1.5" hex head bolts through the frame plate and into the trailer frame. Assemble with lock washers and nuts
inside the frame. Torque bolts to 85 ft-lb.
12. Install jam nut on long set screw. Install long set screw in the frame bracket. Tighten the set screw until it contacts the frame.
Then tighten 1/4" turn more. ( DO NOT OVER TIGHTEN BOLT ) Tighten jam nut.
13. Repeat the previous steps for the other side of the frame.
NOTE: From time to time it may be necessary to use a different chain link to properly level tow vehicle and trailer due to weight
changes in tow vehicle or trailer, or trunnion wear. Any time a different link is used, the cam arm must be readjusted. Loosen the
outside nut as shown at the top of page 4 and adjust the inside nut until the spring bar detent and the cam are aligned. Level tow
vehicle per Reese Installation Instructions for Weight Distribution. Recheck alignment periodically. The 1" lock washers may need
to be replaced after multiple uses. See cam arm adjustment on page 3.
MAINTENANCE: C
1. Do not use grease on cam and cam arms. A light coating of Vaseline may be used to reduce noise. The Dual Cam was designed
to use metal-to-metal friction. Heavy greasing of the cam and cam arm surfaces will affect performance. If noise is offensive, a very
light coating of lubricant, such as Vaseline, may be used. Tongue weights over 1,200 lbs., may require a light coating of lubricant to
reduce friction and prevent excessive wear.
2. Check for excessive wear on any contact surfaces and replace if necessary.
WARNING!
WHILE LIFTING SNAP-UP BRACKET, AND DURING REMAINDER OF SETUP, KEEP
HANDS AND FEET AWAY FROM CAM ARM AND UNDER SPRING BARS. COMPONENTS ARE LOADED
WITH SUBSTANTIAL FORCE AND COULD SHIFT POSITION OR DROP SUDDENLY CAUSING SERIOUS
INJURY.
Cequent Performance Products warrants its Hitches, Custom Hitch Receivers, and Sway Controls from date of purchase against defects in material and
workmanship under normal use and service, ordinary wear and tear excepted, for the ownership life of the original consumer purchaser.
Cequent Performance Products will replace FREE OF CHARGE any part which proves defective in material or workmanship when presented to any Cequent C t P f P d
Performance Products dealer, Cequent Performance Products Warehouse or return to factory. TRANSPORTAION CHARGES PREPAID, at the address below.
THIS WARRANTY IS LIMITED TO DEFECTIVE PARTS REPLACEMENT ONLY. LABOR CHARGES AND/OR DAMAGE INCURRED IN INSTALLATION OR
REPLACEMENT AS WELL AS INCIDENTAL AN CONSEQUENTIAL DAMAGES CONNECTED THEREWITH ARE EXCLUDED.
Some states do not allow the exclusion or limitation of incidental or consequential damages, so the above limitation or exclusion may not apply to you.
Any damage to the Hitch, Custom Hitch Receiver, and Sway Control as a result of misuse, abuse, neglect, accident, improper installation, or any use violative of
instructions furnished by us, WILL VOID THE WARRANTY.
This warranty gives you specific legal rights, and you may also have other rights which vary from state to state. In the event of a problem with warranty service or
performance, you may be able to go to a small claims court, or a federal district court.
26002N 05MAY10K
LIMITED LIFETIME WARRANTY
Hitches - Custom Receivers - Sway Controls
t ill l FREE OF CHARGE
PCN12509 ©2003 REESE PRODUCTS, INC
t hi h d f ti i
Cequent Performance Products
47774 Anchor Court West
Plymouth, Mi. 48170
t i l k hi h
PRINTED IN XXXXXX
t d t C t
5