Product Maintenance - Fellowes POWERSHRED 425Ci Manuel D'instructions

Masquer les pouces Voir aussi pour POWERSHRED 425Ci:
Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 6
ADvANCED PRODUCT FEATURES
SAFESENSE
TECHNOLOGY OPERATION
®
Automatically stops when hands touch the paper opening.
SET-UP AND TESTING
2
1
Turn the shredder on to
Touch test area and
activate SafeSense
look for the SafeSense
®
indicator to illuminate

PRODUCT MAINTENANCE

CLEANING AUTO-START INFRARED SENSORS
Paper detection sensors are designed for maintenance free operation. However, on rare occasions, the sensors may become blocked by paper dust causing the motor to run
even if there is no paper present.
(Note: two paper detection sensors are located in the center of the paper entry.)
TO CLEAN THE SENSORS
2
1
Turn off and unplug
Lift CD flap
shredder
AUTO OIL
TM
Automatically oils the cutters to enhance performance and extend shredder life.
(Auto oil system is only included on cross-cut models - 425Ci and 485Ci)
REFILLING THE OIL
2
1
Low oil indicator will
To maintain shredder
signal when your reservoir
performance, refill oil
needs refilling
reservoir with up to 12
oz. (355 ml.) of shredder
oil (Fellowes 35250)
• All cross-cut shredders require oil for peak performance. If not oiled, a machine may experience diminished sheet capacity, intrusive noise when shredding and
could ultimately stop running. We recommend that you refill the Auto Oil
• If shipping shredder, oil must be drained. Open cabinet door and remove basket to access oil drain plug. Place suitable container under drain,
remove plug and let oil drain out. Replace plug.
3
SafeSense
is active and
®
working properly
®
3
4
Locate Auto-start
Dip cotton swab in
infrared sensor
rubbing alcohol
3
Once refilled, automatic
oiling will resume
reservoir as instructed for optimum performance.
TM
Models 425Ci/425i/485Ci/485i
SLEEP MODE OPERATION
Energy saving feature shuts down the shredder after
2 minutes of inactivity
WHEN IN SLEEP MODE
2
1
To get out of sleep mode
In sleep mode
touch control panel
5
Using cotton swab, wipe
away any contamination
from the paper sensors
ENGLISH
3
or
insert paper
4

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

Powershred 425iPowershred 485ciPowershred 485i

Table des Matières