Safety Notice; Fcc Compliance Statement - AIPTEK T25 Manuel D'utilisation

Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

T25's User's Manual

Safety Notice:

1. Do not let the projector fall down, and do not damage or deattach the product;
otherwise your warranty will be void.
2. Avoid any contact of the device with water and dry your hands before using the
device.
3. Do not expose the projector to high temperatures and direct sunlight.
4. Handle the product with care. Avoid contact with sharp objects. Keep device off
from metallic objects.
5. For your own safety, do not use the projector during thunderstorms or lightning.
6. Only use accessories recommended from the manufacturer.
7. Keep the projector out of reach from children.
8. Avoid facing directly into the projector's lens.

FCC Compliance Statement:

This device complies with Part 15 of the FCC Rules. Operation is subjected to the
following two conditions: (1) this device may not cause harmful interference, and (2)
this device must accept any interference received, including interference that may
cause undesired operation.
This equipment has been tested and found to comply with limits for
a Class B digital device, pursuant to Part 15 of the FCC rules. These
limits are designed to provide reasonable protection against harmful
interference in residential installations. This equipment generates,
uses, and can radiate radio frequency energy, and if not installed
and used in accordance with the instructions, may cause harmful
interference to radio communications.
However, there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause interference to radio or television
equipment reception, which can be determined by turning the equipment off and
on, the user is encouraged to try to correct the interference by one or more of the
following measures:
- Reorient or relocate the receiving antenna.
- Move the equipment away from the receiver.
- Plug the equipment into an outlet on a circuit different from that to which the
receiver is connected.
- Consult the dealer or an experienced radio/television technician for additional
suggestions.
You are cautioned that any change or modifications to the equipment not expressly
approved by the party responsible for compliance could void your authority to
operate such equipment.
www.aiptek.eu
Page 2

Publicité

Table des Matières
loading

Table des Matières