Installation Instructions; Electrical Connections - TurhanCelik 630 Serie Mode D'emploi

Installation, modifications and maintenance of the appliance must be carried out by authorised personnel in
compliance with current safety standarts.
The manufacturer declines all responsibility for failure to comply with these obligations.
 The instructions contained in this manual give important regarding security for installing and maintaining the
appliance. The manufacturer recommends that this manual be carefully stored in the work zone where it can be
consulted by technicians and workers.
 Electric connection of the appliance must be according to the instructions given on the technical data table and electric
scheme.
 Disrespect of the instruction given by producer with the appliance (Use, maintenance, electric connectin, technical
data table and data plate) may compromise the appliance safety and will result in immediate loss of the warranty. The
manufacturer declines all responsibility for injury or damage to persons or things, due to disrespect of the instructions.
INSTALLATION
Positioning
 The appliance should be placed under an exhaust hood to remove smoke and smell which may
cooking process.
 Position the appliance at least 10 cm from surrounding walls. This distance may be reduced if the walls are
flameproof or protected by insulating material.
Assembly
 The appliance should be placed on a flat surface by balancing it due to its four adjustable feet.
 Remove the protective nylon on the appliance. If sticky particles left on the appliance, clean them with a suitable
solvent.
 Level the appliance using the adjustable feet.
 Appliances of 40cms in width installed alone must be fixed to the floor using the special flanged feet.
 In the case of cantilever installations, refer to the corresponding instructions.
Joining appliances together in line (Fig. 1)
 Place the appliances side by side and level to the same height.
Join the appliances by use of the special fixing holes on the side of the fryer.

Electrical connections

 The appliance is designed to operate at the voltage indicated on the data plate.
 Each appliance must be connected to the power supply by a suitably dimensioned independent line (the total power is
indicated in the "Technical data" table). A flexible rubber cable with insulation specifications not lower than type H
07 RN-F must be used for connection to the temiinals.
 The length of conductors between the cable clamp and terminals must be such that the live wires are pulled taut before
the ground wire (yellow-green) if the cable is worked loose from the clamp.
 Multi-pole main isolating switches of suitable current ratin. (with minimum contact-breaking distance of 3 mm) must
be installed, as well as automatic residual current switches of suitable high sensitivity.
 There should be a automate fuse between the appliance and the network.
 Voltage changes should not exceed  %10V.

INSTALLATION INSTRUCTIONS

WARNINGS
occur during the