Grounding Instructions - Greenlee UT10 Ultra Tugger Manuel D'instructions

SPECIFIC SAFETY RULES AND SYMBOLS
Inspect puller and accessories before use. Replace
any worn or damaged components with Greenlee
replacement parts. A damaged or improperly assem-
bled item can break and strike nearby personnel with
sufficient force to cause severe injury or death.
Entanglement hazard:
• Do not operate the cable puller while wearing
loose-fitting clothing.
• Retain long hair.
Failure to observe this warning could result in severe
injury or death.
Wear eye protection when using this
tool. Failure to wear eye protection
could result in severe eye injury from
flying debris.

Grounding Instructions

Electric shock hazard:
Connect this tool to a grounded
receptacle on a 20 amp GFCI-
protected circuit.
Failure to observe this warning could
result in severe injury or death.
This tool must be grounded. In the event of a malfunc-
tion or breakdown, an electrical ground provides a path
of least resistance for the electric current. This path of
least resistance is intended to reduce the risk of electric
shock to the operator.
Greenlee Tools, Inc.
®
Ultra Tugger 10 Cable Puller and Pulling Packages
7
When using the wheeled carriage to transport the
UT10:
• Keep personnel out of the path of transport.
• Evaluate the terrain over which the carriage is to
move. If in doubt, obtain additional help and move
the carriage slowly.
• Do not transport over inclines of more than 15°.
• Do not transport the carriage with boom tubes
longer than the supplied 3' and 4' tubes.
15°
Note: Keep all decals clean and legible, and replace
when necessary.
This tool's electric cord has a grounding conductor and
a grounding plug as shown. Do not modify the plug.
Connect the plug to receptacle that is properly installed
and grounded in accordance with all national and local
codes and ordinances. Do not use an adapter.
20 Amp / 115 Volt
Plug and Grounded Receptacle
Plug
4455 Boeing Dr. • Rockford, IL 61109-2988 USA • 815-397-7070
Receptacle