Setting The Current Time And Date; Erasing Any Prior Programs - Irritrol Total Control Mode D'emploi

SETTING THE CURRENT TIME AND DATE

Before you can program the controller for automatic watering, you must set the controller
clock to the current time and date. This controller features a 365-day calendar with
automatic leap year compensation. Once the date is set, the controller keeps track of
the date and enables trouble-free, odd-even day of the month watering required in some
locations. The time and date apply to all programs. To set the time and date, follow the
steps below.
1. Turn the Function Dial to the
The Hour digits and
+
2. Press the button to increase or
NOTE:
Continuous pressure on the
rapidly.
NEXT
3. Press the
+
Use the and/or
NEXT
4. Press the
+
Use the and/or
NEXT
5. Press the
+
Use the and/or
NEXT
6. Press the
+
Use the and/or
7. Return the Function Dial to the
and date have been set.

ERASING ANY PRIOR PROGRAMS

This process enables you to easily clear the controller memory of all user-defi ned watering
program information within an individual program. This is an optional procedure and can
be skipped if you wish to retain previous program operating information or the controller
has not yet been programmed.
Erasing a program resets the memory to factory conditions: No station time, program start
time or active water days. Season Adjust is set to 100% and Master Valve/Pump Start is set
to be "On."
NOTE:
This process is program independent and resets only the information for the
selected program.
To erase program information for a selected program:
1. Select Program
2. Turn the function dial to the
The display will show "ERASE".
3. Press and hold the
4. Repeat this procedure for each program you wish to erase.
10
Current Time & Date
AM/PM
will fl ash.
–
button to decrease the hour digit.
+
button to select the minutes digits.
–
buttons to set the current minute.
button to select the year digits.
–
buttons to set the current year.
button to select the month.
–
buttons to set the current month.
button to select the day digit(s).
–
buttons to set the current calendar day.
RUN
A B C D
, , or with the program switch.
Program Erase
OFF
button until "DONE" is displayed.
position.
–
or buttons, causes the display to change
position when the current time
position.