Stop Switch; Cutting Attachment Guard - Husqvarna 128CD Manuel D'utilisation

SAFETY INSTRUCTIONS
Throttle lock- -out
S Make sure the throttle control is locked
at the idle setting when the throttle lock- -
out is released.
S Press the throttle lock- -out and make
sure it returns to its original position
when you release it.
S Check that the throttle control and
throttle lock- -out move freely and that the
return springs work properly.
S See instructions under the section
"Start". Start the machine and apply full
throttle. Release the throttle and check
that the cutting attachment stops and re-
mains at a standstill. If the cutting attach-
ment rotates with the throttle in the idle
position then the carburetor idle setting
must be checked. See instructions under
the section "Maintenance".
115374327 Rev. 6 5/31/12

Stop switch

S Start the engine and make sure the engine
stops when you push and hold the stop
switch.

Cutting attachment guard

S Ensure that the guard is undamaged and
is not cracked.
S Replace the guard if it has been exposed
to impact or is cracked.
S Always use the recommended guard for
the cutting attachment you are using. See
section on "Technical data".
Muffler
S Never use a machine that has a faulty
muffler.
S Regularly check that the muffler is securely
attached to the machine.
S The muffler on this unit is equipped with a
special spark arrestor mesh. The mesh
should be checked and, if necessary.
cleaned by a servicing dealer. A blocked
mesh will cause the machine to overheat,
which can lead to serious damage. Never
use a muffler with a defective spark arres-
tor mesh. See the Maintenance section.
English--- 6