Before First Use - Vollrath JT2 Manuel D'utilisation

SET UP
1. Place the toaster on a hard, flat, stable surface.
2. Turn the toaster on it's side with the bottom facing you.
3. Install the feet.
NOTICE: Feet must be installed. Failure to install the feet will
restrict airflow and cause the toaster to overheat.
4. Install the collection pan by placing the back edge of the pan on the
lip at the back of the toaster. Line up the hole in the pan with the
screw. Tighten the screw to secure the collection pan.
FEATURES
A
B
Back View
A Conveyor Speed Control Knob
Full Power - maximum heat
Off
Standby - reduces electrical consumption by up to 75%.
C Heat Shield - Adjustable on the high-clearance toasters
D Feed Ramp
E Crumb Tray
F Top Heat Control Knob
2
C
D
E
F
G
H
I
B Power Knob
G Bottom Heat Control Knob
H Collection Pan
I Reset Button (Reference
only. Access is via the front
of the toasters. See page 3.)
Conveyor Toasters, 350-1000 Slices Per Hour* Operator's Manual – Models JT2, JT2H, JT3, JT3H

BEFORE FIRST USE

1. Clean the toaster. See "Daily Cleaning" on page 3.
OPERATION
CAUTION
Burn Hazard
Do not touch the equipment while it is heating or operating.
Hot surfaces can burn skin.
NOTICE: The crumb tray must be installed in the toaster during
operation. Failure to install the crumb tray will cause the
toaster to overheat.
Adjust the Heat Shield (Models JT2H and JT3H)
Excess space above the product will create heat loss and may reduce
performance.
1. When the equipment is cool to the touch, use a screwdriver to
loosen the screw on the heat shield.
2. Grasp the shield and pull it up or down to adjust the opening so the
tallest products can pass through. Re-tighten the screw.
Preheat
Plug the toaster into a grounded electrical outlet that matches the rating
on the name plate found on the side of the toaster.
NOTICE: Using a voltage other than the nameplate rated voltage will
cause damage to the unit. Incorrect voltage, modification
to the power cord or electrical components can damage
unit and will void the warranty.
1. Rotate the power knob to the full power position (I).
2. Set the conveyor speed control knob to 7.
3. Rotate the top and bottom heat control knobs to high.
4. Wait 5 minutes for the toaster to preheat.
Test
1. Adjust the settings for the product to be toasted.
Tips
Product
Bagels, wheat or rye bread or
products with high moisture content.
Buttered or coated, such as pastries Not recommended.
Frozen
2. Test the settings by placing a sample of the food to be toasted onto
the feed ramp. Place bagels or buns onto the feed ramp with the cut
side facing up.
For One-Sided Toasting
TOP heat control to the desired setting.
BOTTOM heat control to the OFF position.
Toast the Bread
1. Adjust the top and bottom heat control settings and conveyor as
needed for even toasting. Allow time for the toaster to adjust to new
heat settings before placing bread or sandwiches on the
2. For best performance do not overload the toaster. Wait a few
seconds before loading a second row of bread or sandwiches into
the toaster.
Suggestions
Use a slower conveyor speed.
Must be thawed before toasting.
conveyor.