Cleaning And Maintenance - IRIS USA SDR-C1 Instructions D'utilisation

HOW TO USE
Stop Running the Product While in Use
Press the ON/OFF button while in use to stop the product .
If the internal temperature becomes too high, the product will cool down
for 30 seconds and then stop running .
Other Uses
When the product is used to dry shoe cabinets:
• Stretch the hose out and place it inside the shoe cabinet to let warm
air blow inside .
• Close the shoe cabinet doors/lids as much as possible to allow the
warm air to circulate more efficiently .
• Do not put the product directly inside the shoe cabinet .
• Be careful not to close the doors/lids too tightly . Doing so might
damage the hose .
Safety Mode to Prevent Overheating
Safety mode will be triggered when the product overheats . All indicators
will turn off, a buzzer will sound, and the product will cool down for 30
seconds before shutting off .
After the product shuts off, please wait until it cools down completely and
then check the following before restarting it:
• Is the air entry port or air outlet clogged?
• Is the product being used in too tight of a space?
Mode Recommendations
Type of Shoes
Damp
Sneakers
Wet
Damp
Boots
Wet
Leather shoes
* The recommendations are based on the assumption that excess water has been wiped off with a dry cloth .
* Drying times differ due to materials, type of shoes, shoe size, level of dampness, and room temperature and moisture
levels . Please extend the drying time if the shoes are not dried completely .
* Drying time should be extended if drying two pairs of shoes at the same time .
* Excessive drying may cause damage to leather shoes . Check the shoes within the first thirty minutes of drying to prevent
them from being excessively dried . Polish shoes after drying to help maintain their condition .
Mode Time
HIGH 30 minutes
HIGH 120 minutes
HIGH 30 minutes
HIGH 120 minutes
MEDIUM 30 minutes
7

CLEANING AND MAINTENANCE

Make sure the product has completely cooled down before cleaning . Unplug the power plug from
the electric socket before cleaning . Do not get the unit wet, or put the unit in water .
CAUTIONS
Use of strong cleaning agents such as amylacetic ester, alcohol, oil, etc . can cause fading,
deformation or breakdown .
Main Body
Use a soft cloth soaked in cool water (below 104°F/40°C) to wipe off the dust .
If the dust is hard to remove, wipe with a cloth soaked in mild neutral
detergent and then wipe off the detergent with a fully wrung cloth .
Air Entry Port and Air Outlet
If dust has accumulated in air entry port or air outlet, use a vacuum cleaner to
clean it .
8