Planetary Mixing System; Before First Use; Selecting Attachment Types; Appliance Assembly And Disassembly - Sencor STM 3010WH-NAA1 Mode D'emploi

STM 3010WH-NAA1 / STM 3011GR-NAA1 / STM 3012BL-NAA1 / STM 3013OR-NAA1 / STM 3014RD-NAA1
STM 3015VT-NAA1 / STM 3016YL-NAA1 / STM 3017TQ-NAA1 / STM 3018RS-NAA1 / STM 301XXX-NAA1

PLANETARY MIXING SYSTEM

• The planetary mixing system is based on the principle of dual rotation of the attachment. The
attachment rotates counterclockwise along the inner perimeter of the bowl while rotating around
its own axis in the opposite direction. This ensures that ingredients inside the bowl are processed
thoroughly and evenly.

BEFORE FIRST USE

1. Take the appliance and its accessories out of the packaging materials.
2. Thoroughly wash all parts that are intended to come into contact with food (dough hook A1,
whisk A2, beater A3 and the stainless steel mixing bowl A4) using warm water and a neutral
kitchen detergent. Then rinse them with clean water and dry thoroughly with a fi ne towel.

SELECTING ATTACHMENT TYPES

ATTACHMENT TYPE
Dough hook A1
Beater A3
Whisk A2

APPLIANCE ASSEMBLY AND DISASSEMBLY

• Before you start assembling or disassembling the food mixer, check that it is turned off and
disconnected from the el. power socket.
1. Inserting the mixing bowl
1.1 Place the food mixer on an even, dry surface, e.g. on a kitchen counter.
1.2 Release the arm A7 by pressing the PUSH button A8 and tilt it upwards. The arm A7 is locked in
the open position when the PUSH button A8 slides out together with an audible click.
1.3 Place the stainless steel bowl A4 into the hole in the base unit A5 and secure it in place by turning
it clockwise. When the bowl A4 is properly attached, it is not possible to lift it off the base unit
A5.
2. Attaching an attachment (dough hook, beater or whisk)
2.1 When attaching an attachment, the arm A7 must be secured in the open position - see point
1.2 in chapter Inserting the mixing bowl. Attach one of the attachments to the T-shaped shaft of
the mixing head A6 so that the shaft fi ts into the hole on the attachment. Push the attachment
towards the mixing head A6 and turn it counterclockwise to secure it to the shaft.
2.2 With one hand, hold the attachment and gently pull it downwards. If it is properly secured to the
shaft, it will not come off.
2.3 If you will not be immediately placing ingredients into the mixing bowl A4, press the PUSH button
A8 and tilt the arm A7 to the horizontal position. When the arm A7 is tilted to the horizontal
position, the PUSH button A8 will slide out accompanied by an audible click.
2014
Table Mixer
PURPOSE OF USE
This is used for kneading and preparing heavy and thick doughs containing
yeast, e.g. bread dough.
This is used for mixing medium-heavy and lighter doughs not containing
yeast, for mixing sauces, creams, fi llings, etc.
This is used for whisking whole eggs or egg whites, whipped cream, light
doughs, foamy creams, etc. Do not use it for mixing heavy and thick doughs.
EN-5
11/2014