Connecting The Central Vacuum Unit - Integra VAC Mode D'emploi

INTEGRA VAC
- Central Vacuum Systems

5. CONNECTING THE CENTRAL VACUUM UNIT

ELECTRICAL CONNECTIONS
SIDE VIEW
REAR VIEW
INSTALLING THE CENTRAL VACUUM UNIT
1. BENEATH A KITCHEN CABINET
MARK THE POSITION OF THE INTEGRAVAC AND CUT OUT THE PLINTH TO FIT THE UNIT.
For this a mínimum plinth height of 145mm is required.
CONNECTION OF THE CENTRAL VACUUM UNIT TO THE PIPE NETWORK AND THE CENTRAL VACUUM
EXHAUST.
MARK THE POSITION OF THE REAR OF THE DRAWER COMPARTMENT ON
THE BOTTOM OF THE KITCHEN CABINET TO ENSURE IT LINES UP WITH
REQUIRED DIMENSIONS OF THE GAP IN
CONNECTION TO THE CENTRAL VACUUM EXHAUST
CONNECTION TO THE CENTRAL VACUUM PIPE NETWORK
It is recommended that the central vacuum unit is
connected both to the pipe network and the exhaust
by means of 50mm diameter pipe 40cm in length
(included in the box) in length with a view to
facilitating easy removal of th
vacuum unit at a later date, should this be required.
33
User guide
ON/OFF SWITCH
SOCKET FOR POWER LEAD
LOW VOLTAGE CONNECTION
TO INLET VALVES
INTEGRA VAC
KITCHEN PLINTH
THE PLINTH WHEN INSTALLED.
200mm
THE KITCHEN PLINTH
INTEGRA central