Table des Matières
Publicité
SS-0
Safety precautions: Before commencing mounting work
on roofs, it must be ensured in all cases that the non-
personal fall protection and fall-arrest systems required by
DIN 18338 (Roof Covering and Roof Sealing Works) and
DIN 18451 (Scaffolding Works) are in place. See also
Builders' Protection Ordinance
[Bauarbeiterschutzverordnung], Federal Law Gazette 340/
1994, paragraphs 7-10! Other country-specific regulations
must be observed!
If non-personal fall protection or fall-arrest systems cannot
be installed for technical reasons, all personnel must be
secured by means of suitable safety harnesses!
Only use safety harnesses (safety belts, lanyards and
straps, shock absorbers, fall arresters) that were tested
and certified by authorized testing bodies.
If non-personal fall protection or fall-arrest systems are not
provided, working without the use of suitable safety
harnesses may lead to falls from heights and therefore
cause serious or lethal injuries!
Ladders not properly secured against sinking in, sliding or
falling over may lead to dangerous falls!
Whenever you are near live overhead electric cables
where contact is possible, only work if:
it is ensured that they are voltage-free and this is
secured for the duration of work.
the live parts are secured by covering them or
cordoning them off.
the prescribed safety distances are maintained.
Voltage radius:
1 m ...........................voltages up to 1000V
2 m ...........................voltages from 1000V to 11000V
3 m ...........................voltages from 11000V to 22000V
4 m ...........................voltages from 22000V to 38000V
> 5 m in case of unknown voltages
The manufacturer hereby guarantees to take back
products identified with an eco-label and to recycle the
materials used. Only the heat transfer medium specified
may be used!
8
Safety harnesses should be fixed above the users
whenever possible. Safety harnesses should only be
fastened to sufficiently load-bearing structures or fixing
points!
Never use damaged ladders (e.g., wooden ladders with
split runners or rungs, or bent or buckled metal ladders).
Never try to repair broken runners, rungs or steps on
wooden ladders!
Ensure that ladders are put up safely. Observe the correct
leaning angle (68° - 75°). Prevent ladders from sliding,
falling over or sinking into the ground (e.g. using wider
feet, feet suited to the ground or hooking devices).
Only lean ladders against secure points. Secure ladders in
traffic areas by suitable cordoning.
Contact with live electric overhead cables can be lethal.
Wear protective goggles when drilling and handling
collectors!
Wear safety shoes when carrying out installation work!
Wear cut-proof safety gloves when mounting collectors!
Wear a helmet when carrying out installation work!
EN
Sicherheitshinweise
Safety information
Avvertenze per la sicurezza
Instructions de sécurité
Advertencias de seguridad
Publicité
Table des Matières
