Best Power Fortress 750 VA Guide D'utilisateur page 10

For B41 model: Connect the cord that came with the UPS to the server. Then plug it into an
outlet on the back of the Fortress.
7 Switch on the protected equipment, one unit at a time. If the UPS beeps an alarm when you
start your equipment, the UPS may be overloaded; go to the Troubleshooting section on
page 11.
The bottom four lights on the front of the UPS show the percentage of the UPS' power
that your equipment is using. See Symbols, LEDs and Audible Beeps Section for more
information.
8 The RJ-11 or RJ-45 Surge Protection jacks will protect equipment that
uses an RJ-11 or RJ-45 connection. Plug the 10BASE-T network
connection (or phone, fax or modem line for B40, B42, B44, and U
models) into the surge protection jack labeled "IN" on the back of the
Fortress. Plug the protected equipment into the surge protection jack
labeled "OUT." Network cabling is not provided. Network only on
B41 and all "E" models; do not connect any TNV equipment such as
telephone, fax or modem to the circuitry. It may only be used for
network protection purposes, on E models. This connection is
optional. It is not needed to use the Fortress.
ENGLISH 8
RJ-11 or
RJ-45