5.3.1 Registering An Administrator Tag; 5.3.2 Registering A User Tag; Cancelling A Rfid Tag; Cancelling All Rfid Tags - Byron DIC-24112 Mode D'emploi

Instruction manual

5.3.1 Registering an administrator tag

ü You have an unregistered administrator tag.
ü Your doorbell is plugged in.
ü You have a small screwdriver ready to press the registration
button.
A. Press the registration button on the back of the outdoor unit.
ð The LED will flash red.
B. Swipe the unregistered management tag across the RFID sensor
on the doorbell.
ð The device will beep several times to indicate your administrator
tag has been registered.

5.3.2 Registering a user tag

ü Your doorbell is in standby mode.
ü You have a registered administrator tag.
ü You have an unregistered user tag.
ü You have a door lock or gate opener connected. (Make sure to
switch whether to open the gate or door, on the switch behind
the outdoor unit (door bell)). See section "Connecting a door
lock".
A. Swipe your administrator tag across the RFID sensor on your
doorbell.
B. Within 10 seconds, press the call button.
ð The LED will flash red, and the device will beep.
C. Now swipe the unregistered user tag across the RFID sensor on
your doorbell.
D. Press the call button to exit the registration mode.
10
ð The device will beep several times to indicate your tag has been
registered.
5.4

CANCELLING A RFID TAG

ü The doorbell is in standby mode.
ü You have an administrator tag ready, and a tag that needs to be
cancelled.
A. Swipe the administrator tag. The LED will light up white.
B. Within 10 seconds, press the call button. You will hear a beep,
and the LED will start flashing red.
C. Swipe the administrator tag again.
D. Now swipe the tag that you want to cancel. The device will beep to
indicate that the card has been unpaired.
E. Press the call button to exit the registration mode.
5.5

CANCELLING ALL RFID TAGS

You wish to cancel all RFID tags.
ü You have an administrator tag ready.
ü Your doorbell is in standby mode.
A. Press and hold the call button on your doorbell for 3 seconds.
ð You will hear a beep sound, and the LED ring will light up
red.
B. Swipe the administrator tag on the RFID sensor.
ð The doorbell will beep.
C. Press and hold the call button until you hear a beep sound.
ð All your RFID tags are now cancelled.