iMerciv BuzzClip Guide De Démarrage Rapide page 5

Switching Between Modes on your BuzzClip:
Locate the Mode Button – With the BuzzClip in your
palm, you should be able to feel a circular ring at the
top which is the sensor. To the right of the sensor,
there is a rubberized button with NO tactile mark. This
is the Mode button.
1. You can only switch between modes when
the BuzzClip is ON. The device comes with three-modes: a 1-meter mode, a
2-meter mode and a 3-meter mode. We suggest using the 1-meter mode
for indoor use and the 2-meter and 3-meter modes for outdoor use.
2. While the BuzzClip is ON, Press and hold the Mode button to change modes
on your BuzzClip. You should then immediately feel two short rapid
vibrations. This indicates that the BuzzClip is now in the 2-meter mode.
3. Press and hold the Mode button again and you should then feel three short
rapid vibrations. This indicates that the BuzzClip is now in the 3-meter
mode. We recommend using this mode for open areas and general
landscaping of the surrounding environment.
Turning Off your BuzzClip: