Whirlpool ACU088PP0 Guide D'utilisation Et D'entretien page 9

Models without heat
Models with heat
Fan Speed
Models without heat
1. Press and hold FAN SPEED.
2. Choose AUTO, TURBO, HIGH or LOW.
When Auto is selected, the fan speed will change
automatically as the temperature in the room changes.
7º or more above the set temperature will use Turbo.
4º - 7º above the set temperature will use High.
4º or below the set temperature will use Low.
Models with heat
1. Press FAN SPEED.
2. Choose AUTO, HIGH or LOW.
When Auto is selected, the fan speed will change
automatically as the temperature in the room changes.
Cool mode:
7º or more above the set temperature will use High.
7º or less above the set temperature will use Low.
Heat mode:
7º or more below the set temperature will use High.
7º or less below the set temperature will use Low.
Temperature
Press the TEMP plus pad to raise the temperature 1º until it
reaches 88ºF (31ºC).
Press the TEMP minus pad to lower the temperature 1º until it
reaches 66ºF (19ºC).
NOTE: By pressing both pads at once, the display will switch
from ºF to ºC.
Timer Delay
To set the Timer for a 1- to 24-hour delay until the air
conditioner turns on (the air conditioner must be Off):
1. Press TIMER. Indicator light remain on.
2. Press the plus or minus pad to change the delay time from
1 to 24 hours.
3. To turn Timer off, press TIMER again.
To set the Timer delay for a 1- to 24-hour delay until the air
conditioner turns off (air conditioner must be On):
1. Press TIMER. Indicator light will remain on.
2. Press the plus or minus pad to change the delay time from
1 to 24 hours. The display will automatically go back to the
set temperature after 10 seconds.
3. To display the amount of time left, depress TIMER once.
4. To turn Timer off, press TIMER twice.
To operate air conditioner with remote control
NOTE: Remote control may vary in appearance.
NOTE: Two AAA batteries (included) power the remote control.
Replace batteries after 6 months of use, or when the remote
control starts to lose power.
9