Wörlein ELiTE line PL880 Manuel D'instructions page 21

Speed alignment using the Pitch adjustment
The turntable speed is preset. By turning the control in the "+" and "-" directions, you can set the
speed and thereby influence the sound result according to your ear and personal taste.
Tone arm stopping position alignment
- The position of the tone arm complete
playback and return to the rest station can be adjusted at the alignment screw as follow:-
Before starting the alignment, please
take out the hole covering rubber:
a. If the system cannot complete the playback of record and return earlier, use a cross head
screw driver and turning the alignment screw inside the hole clockwise, the stopping and
eject position of the tone arm will move more inward to the center of the record for playback
completion.
b. If the system cannot return to rest position
automatically after playback of record use
a cross head screw driver and turning the
alignment screw inside the hole anti-
clockwise, the stopping and eject position
of the tone arm will move more away from
the center of the record for playback
completion.
Remark:
The stopping position is very subjective
-
among difference customers, please select the most suitable position based on your own
record collection. The ex-factory setting is based on the most common template.
Please check the stopping position time by time during adjustment and avoid over turning of
-
the screw inside
ADJUST THE WEIGHT OF THE STYLUS
1. Slide in the counter weight completely into the rear of the tone arm until it reach the end ,
turn it clockwise until it click with pit inside.
2. Twist the counter weight clockwise & backward until it reach the white line as figure 2
3. Twist the counter marking until it reach " 1 " position
4. Twist the counter weight anti-clockwise & inward until it reach the appropriate working
pressure.
7
PL880 / English Instruction Manual