Horizon Fitness CT9.1 Manuel Du Propriétaire page 4

ASSEMBLY STEP 1
HArDWArE BAG 1 CONTENTS :
BOLT (A) SPRING WASHER (B)
20 mm
8.2 mm
Qty: 6 Qty: 6
LEAD WIRE
CONSOLE MAST
MAIN
FRAME
BOOT CONSOLE CABLE
BOLTS (A)
SPRING
WASHERS (B)
ARC WASHERS (C)
MAIN FRAME BRACKET
6
CT9.1-OM-rev1.3.indd 6-7
A Cut the yellow banding straps and lift the
running deck upward to remove all contents
from underneath the running deck.
ARC WASHER (C)
8.2 mm
Open hardware bag 1.
Qty: 6 B
Slide maiN frame bOOt up CONSOLe
C
maSt. Place right CONSOLe maSt over
maiN frame braCket.
Pull Lead wire through right CONSOLe
D
maSt. After pulling the Lead wire through
the mast, the top of the CONSOLe CabLe
should be located at the top of the mast. Detach
and discard Lead wire.
NOTE: Do not pinch CONSOLe CabLe when
placing the mast onto the maiN frame
braCket.
Attach CONSOLe maSt to maiN frame
E
braCket using 3 bOLtS (a), 3 SpriNg
waSherS (b) and 3 arC waSherS (C).
Slide maiN frame bOOt down over maiN
F
frame braCket.
g Repeat steps D–F on other side.
ASSEMBLY STEP 2
HArDWArE BAG 2 CONTENTS :
BOLT (E) SPRING WASHER (B)
15 mm 8.2 mm
Qty: 4 Qty: 4
BOLTS (E)
SPRING WASHERS (B)
CONSOLE (UPSIDE DOWN)
CONSOLE MAST CAP
Open hardware bag 2.
A
With the CONSOLe upside down, attach the
B
CONSOLe maSt CapS to the CONSOLe
using 4 bOLtS (e) and 4 SpriNg
waSherS (b).
NOTE: The console mast caps are marked with an
L if they are to be used on the left-hand side of the
treadmill or an R if they are to be used on the right-
hand side of the treadmill. If the console mast caps
are assembled on the incorrect side of the treadmill,
the unit will not assemble correctly.
9/3/09 3:54 PM
7