Installing The Dome Cover; Focusing The Dome Camera - Avigilon 1.0-H3-D1 Guide D'installation

5. In the Avigilon Camera Installation Tool, adjust the
camera's Image and Display settings to achieve the
desired zoom position.

Installing the Dome Cover

To install the dome cover, complete the following steps:
1. Rotate the black shield located inside the dome bubble so
that it does not block the camera's field of view. Skip this
step if you are installing a dome camera with IR
illumination.
2. Attach the dome cover to the base by tightening the
tamper-proof screws with the provided tamper resistant
key.
Be especially careful not to mark the dome bubble or the
contaminants will cause unwanted reflections in the -IR
model.
3. Remove the plastic cover on the dome bubble.

Focusing the Dome Camera

NOTE: Ensure this procedure is performed after the dome cover is
installed, so the focus shift caused by the dome bubble's
refraction can be accomodated.
• In the Avigilon Camera Installation Tool, use the camera's
Image and Display settings to focus the camera lens.
a.
b.
Caution — Do not attempt to adjust the focus and zoom on
the camera manually or the camera lens may become
damaged.
Click the Auto Focus button to focus the lens.
If the desired focus was not achieved, use the focus
near and far buttons to adjust the focus.
9