Wiring Connection - Kenwood KDC-BT648U Mode D'emploi

Wiring connection

USB connector
AUX input (Stereo)
Use the mini-plug (3.5 mm; 1/8") cable
which is stereo type and does not have
any resistance.
Fuse (10A)
Wiring harness D
White
White/Black
Gray
Gray/Black
Green
Green/Black
Purple
Purple/Black
If no connections are made, do not let the wire come out from the tab.
Blue/White
(Power control/ Antenna
control wire)
Brown
(Mute control wire)
Light Blue/Yellow
(Steering remote control
wire)
Blue
Red (Ignition wire)
Yellow (Battery wire)
Black (Ground wire)
To the metallic body or chassis of the car
32
English
R
To front left speaker
To front right speaker
To rear left speaker
To rear right speaker
Connect either to the power control terminal when
P.CONT
using the optional power amplifier, or to the antenna
control terminal in the vehicle.
To connect the Kenwood navigation system, consult
your navigation manual.
MUTE
(Connect to the terminal that is grounded when
either the telephone rings or during conversation.
KDC-X395/ KDC-348U only)
To use the steering wheel remote control feature, you
REMOTE CONT
need to an exclusive remote adapter (not supplied)
STEERING WHEEL
matches your car is required.
REMOTE INPUT
(Not used)
ANT. CONT
Car fuse box
ACC
FM/AM antenna
input (JASO)
Rear output
L
Front output
Sub Woofer output
Microphone H
(KDC-X695 only)
To Kenwood disc changer/
External optional accessory
(To connect these leads, refer
to the relevant instruction
manuals.)
Ignition key switch
Car fuse box
(Main fuse)
Battery
– +
Antenna Cord