Wiring Connection - Kenwood KDC-BT268U Mode D'emploi

INSTALLATION/CONNECTION

Wiring connection

IMPORTANT : We recommend installing the unit with a commercially available custom wiring harness specific for your car
and leave this job to professionals for your safety. Consult your car audio dealer.
To front speaker (left)
To front speaker (right)
To rear speaker (left)
To rear speaker (right)
Car fuse box
Ignition switch
Car fuse box
Battery
Output terminals
Antenna terminal Fuse (10 A)
White
White/Black
Gray
Gray/Black
Green
Green/Black
Purple
Purple/Black
Red (Ignition wire)
Yellow (Battery wire)
Black (Ground wire)
To the metallic body or chassis of the car
When connecting to an external amplifier, connect its ground
wire to the car's chassis to avoid damaging the unit.
Microphone input jack ( 12)
If no connections are made, do not let the wire come out from the tab.
Brown
(Mute control wire)
Blue/White
(Power control wire/
Antenna control wire)
(12 V 350 mA)
Light blue/yellow
(Steering remote control
wire)
To connect the Kenwood navigation system,
refer your navigation manual
To the power control terminal when using the
optional power amplifier or to the antenna
control terminal in the vehicle
To the steering wheel remote control adapter
ENGLISH 29