ageLOC GALVANIC SPA Manuel Du Propriétaire page 9

EN
Tru Face Line Corrector
Setting
Use this regimen morning and night to target and soften the
appearance of fine lines and wrinkles around your mouth, eyes,
and forehead.
Preparation: Use after a Nu Skin cleanser
and toner of your choice. Attach the Focus
Area Conductor to the device (Figure 1).
1: Apply Tru Face Line Corrector to
step
the lines and wrinkles you want to target.
Figure 1
Apply to only one of these areas at a time.
Make sure to leave a thin layer of product
on the surface of your skin.
2: Push the selection button until the
step
number 3 is lit on the display (Figure 2). This
application will take 5 minutes.
Pro Tip: When targeting multiple areas,
you can use the five minutes for more than
one area. Small application areas typically
Figure 2
do not require more than one or two
minutes each.
3: Thoroughly wet hands with NaPCA
step
Moisture Mist or water. Hold the device with
a moistened hand while touching the chrome
plate on the back and begin to slowly glide
the conductor head over your skin (Figure 3).
Be careful to avoid sensitive areas like your
eyes, eyelids, and lips.
Figure 3
The device will beep once, twice, or three
times to indicate that it has automatically adjusted to your skin.
14
Conductor
GS 3
After this, your galvanic application has begun, and the device
will beep every 10 seconds to indicate the unit is on and working,
and every 5 seconds when your application is almost complete.
4: When your galvanic application is over, the device will
step
emit a long beep followed by two
short beeps and automatically turn
off. Repeat steps 1 through 3 for
each targeted area. When finished
with all applications, rub any
remaining product into your skin
and wipe any leftover product
from the device with a damp towel
(Figure 4).
EN
Figure 4
15