ageLOC GALVANIC SPA Manuel Du Propriétaire page 7

EN
How to use your ageLOC
Galvanic Spa
ageLOC Galvanic Spa includes different conductors for your face,
scalp, and body, but they are all used in similar ways. Specific
instructions for individual applications can be found on pages 12-19.
Please read the instructions before beginning to use the device.
For each usage, you must attach the appropriate conductor to
your device. The skin touching both chrome contact points
must be moist to successfully conduct galvanic currents.
Attach a Conductor: Hold the device
with the display facing toward you. Align
the conductor positioning indicator with
the front of the device, then press the
conductor firmly down by its sides until it
snaps into place ( Figure 1 ) . If the conductor
Figure 1
doesn ' t connect, make sure it is facing
the right direction and is positioned correctly. Don ' t force the
conductor, as this may damage it. ageLOC Galvanic Spa won ' t
work if a conductor head isn ' t firmly attached.
Remove a Conductor: First turn the
device around so the chrome panel faces
you. With your free hand, grip the
conductor on its sides, and then firmly
press the release button ( Figure 2 ) .
Gently pull the conductor off the device
Figure 2
by its sides.
Display Lights: The display will remain lit while the device is
on, both when selecting and during an application. If the display
blinks on and off, it is either because the device has lost
contact with your skin or skin is not moist enough to conduct
the current.
Apply Product: Apply the recommended amount of product
to the targeted area on your face, scalp, or body.
10
Select Application: Press the selection
button until the desired number is lit
(Figure 3 ) .
Activate Galvanic Current: Your fingers
must be touching the chrome panel on the
back of the device while the conductor
touches your skin. We recommend you
thoroughly wet your hands with water or NaPCA Moisture Mist
to improve conductivity. * If your fingers slip off the chrome panel
during use, don ' t worry—just adjust your hold on the device and
resume your spa regimen.
* Remember, the skin touching both chrome contact points must
be moist to successfully conduct galvanic currents.
During Application: The device will beep every 10 seconds
to indicate the unit is on and working. When 30 seconds
remain in an application, the device will beep every five
seconds until the application is complete.
Application Interruption: You must
keep the conductor in contact with the
area being targeted and keep all contact
points moist ( Figure 4 ) . If you break
contact with the chrome panel or the
application head, the display will flash on
and off. The device will shut off after a
couple minutes of non-use.
Application Completion: At the end of your regimen, the
device will emit a long beep followed by two short beeps and
automatically turn off. If you ' d like to perform another
application, press the selection button to scroll to the next
application number. To turn the device off at any time, simply
press the selection button until the display goes blank.
Discontinue use if you experience swelling, redness, or a
skin reaction.
EN
Figure 3
Figure 4
11