Check Before Operation - TOOLWAY BOLTON PRO 192021 Mode D'emploi

Be sure of what you are pumping. This pump is designed to pump only fresh water that is
not intended for human consumption.
For your safety, and to maximize the service life of your equipment, it is very important to
take a few moments before you operate the pump to check its condition. Be sure to take
care of any problem you find, or have your servicing dealer correct it, before you operate
the pump.
Improperly maintaining this pump, or failing to correct a problem
before operation, could cause a malfunction in which you could be
seriously injured.
Always perform a pre-operation inspection before each operation, and correct any
problem.
Exhaust gas contains poisonous carbon monoxide. Avoid inhalation of exhaust gas. Never
run the engine in a closed garage or confined area.
To prevent fire hazards, keep the pump at least 3 feet (1 meter) away from building walls
and other equipment during operation. Do not place flammable objects close to the engine.
Before beginning your pre-operation checks, be sure the pump is on a level surface and
the ignition switch is in the OFF position.
Check the General Condition of the Pump
Look around and underneath the pump for signs of oil or gasoline leaks.
Remove any excessive dirt or debris, especially around the engine muffler, and recoil
starter.
Look for signs of damage.
Check that all nuts, bolts, screws, hose connectors and clamps are tightened.
Check the Suction and Discharge Hoses
Check the general condition of the hoses. Be sure the hoses are in serviceable condition
before connecting them to the pump. Remember that the suction hose must be reinforced
construction to prevent hose collapse.
Check that the sealing washer in the suction hose connector is in good condition .
Check that the hose connectors and clamps are securely installed .
Check that the strainer is in good condition and is installed on the suction hose .

CHECK BEFORE OPERATION

7