Philips 9000 Série Mode D'emploi page 28

28
English
Problem
I replaced the
shaving heads,
but the display
still shows the
replacement
reminder.
A shaving
unit symbol
has suddenly
appeared on the
display.
An exclamation
mark has
suddenly
appeared on the
display while
the appliance is
charging.
Possible cause
You have not reset
the appliance.
This symbol
reminds you to
replace the shaving
heads.
The appliance is
overheated.
Solution
To clean the shaving
heads thoroughly, remove
the shaving heads
from the shaving head
holder one by one (see
'Replacement'). Then
separate the cutter from
its guard and rinse each
matching set under the
tap. After rinsing, place
the cutter back into its
corresponding guard.
Finally, put the shaving
heads back into the
shaving head holder (see
'Replacement').
Reset the appliance by
pressing the on/off button
for approx. 7 seconds.
Replace the shaving heads
(see 'Replacement').
Disconnect the appliance
from the wall socket for
approx. 10 minutes.