sanowell ActiveSpa Mode D'emploi page 13

•
Do not pull or carry the device by the cable.
•
Pay special attention to proper use whenever the device is used by or close to children
or disabled persons.
•
The device is not intended for commercial use. Use the device only for the intended
purpose as described in the instruction manual.
•
The voltage of the device must match the local supply voltage.
•
The device must be connected via a ground fault circuit interrupter that trips at a
leakage current of 30 mA. Attention: Observe the regulations for such devices in your
country (US: BS 7671).
•
Never leave the device unattended when it is switched on.
•
Never cover the air slots on the bottom of the device.
•
Do not keep using the device in case of a malfunction. Ask your specialist supplier and
have repairs performed only by authorized service points.
•
If you suffer from medical foot conditions, venous disease or diabetes, or if you
experience health problems while using the bubble spa, consult your doctor.
3. Using the bubble spa
3.1. Positioning the bath mat and the air hose
Place the bath mat into the wet bathtub and press down fi rmly on the suction cups to
make them stick to the fl oor of the tub. The bath mat has extra-large suction cups for your
safety. Please always step on the middle of the bath mat to prevent slipping at the edge.
Also, always hold on to the rim of the tub and the handle at the wall when stepping onto the
mat.
Insert the connector of the air hose into the opening at the air distributor of the bath mat.
Press lightly and turn the connector to connect the hose to the mat. Connect the connector
at the other end of the hose to the blower unit in the same way. Attention: Please press
the hose only lightly into the openings to avoid damaging the mat or the blower unit.
In accordance with safety regulations, your sanowell ActiveSpa bubble spa is equipped with
a safety system integrated in the blower unit. This system prevents water from entering
the unit via the air hose. Hence, a conventional non-reverse ratchet at the air hose is
unnecessary.
Do not fi ll warm water into your tub until you have pressed the bath mat to the tub fl oor
and connected the mat and the blower unit to the hose. Please note that the water level
may not be higher than 40 cm.
3.2. Positioning the blower unit
Place the blower onto a stool without upholstery so that it cannot tip over. Place the device
at least 60 cm away from the bathtub to keep it from falling in.
Do not place towels, carpets or similar items under the unit, as this would block the air
slots.
EN