Multilogger Information - Arexx BS-510 Mode D'emploi

1b. MULTILOGGER INFORMATION
QUICK START
- Please read this manual first.
- Install the Multilogger Software
- Connect the BS-510 with the USB cable to a PC
- When sensors are active, the receive LED will blink each time it receives data.
- Start the Logger Software
E
N
G
L
I
S
H
• The BS-510 receives the measurements from the sensors wirelessly.
• The temperature sensors transmit their data to the BS-510.
• Many sensors (about 60) can be connected to the system at the same
time.
• Separate sensors for the Temperature Logger are available at your dealer.
• We have connected 60 sensors to one single receiver without any
problems.
• The BS-510 shows the sensor measurements of a longer period of tim
graphically on the PC with the multilogger software.
• The range of the sensors can vary as a result of environmental influences.
• Depending on the material properties of the surrounding areas, sensor
located inside refrigerator systems may not be able to communicate with
the receiver.
Depending on the material properties of the surrounding areas, sensors located
inside refrigerator systems may not be able to communicate with the receiver.
The latest software is available at
http://www.arexx.com/templogger
The latest software, documentation and manuals see:
http://www.arexx.com/templogger
35