Starting Up; Switching On; Activating Consumers - Schaudt LT 45X Instructions De Service

General information
on using
the touch sensors
3.2
230V mains operation
3.3
3.4
9310330 BA / EN
Operating Instructions Operator and control panel LT 45X
The LT 45X control panel has touch-sensitive sensors. These sensors react
when touched with a bare finger. The LT 45X control panel cannot detect
touches when gloves are worn (such as for camping in winter). Gloves must
therefore be removed before use.

Starting up

Switch on the LT 45X control panel (see Section 3.3).
"
Connect the input to the mains supply of the vehicle to the 230V mains
"
supply.
Mains indicator LED lights up. The leisure area battery is being charged. For
details on the charge functions, refer to the operating instructions for the re-
levant power supply (EBL ...). .

Switching on

The 12V supply of the vehicle is switched on from the relevant button. The
refrigerator controller is an exception. It also works when the 12V power
supply is switched off -- refer to the operating instructions for the relevant
power supply (EBL ...). .
Touch the sensor for the main 12V ON/OFF switch
"
The green indicator LED lights up
F
The 12V leisure area supply is switched on
F

Activating consumers

The following consumers are switched on and off by the LT 45X control pa-
nel (maximum configuration for LT 450, refer also to the table on Page 2):
Water pump
F
Lighting
F
AUX or "Multimedia" (e.g. for radio or TV, refer also to the operating
F
instructions from the vehicle maker).
Touch the relevant sensor
"
The yellow indicator LED lights up
F
The relevant supply voltage is enabled
F
Touch the relevant sensor again
"
The yellow indicator LED goes out
F
The relevant supply voltage is disabled
F
Switching on the water pump supply switches on a pressure pump con-
Y
nected (briefly as required).
Date: 29.05.2020
7