Technical Specifications - Weelko EPILCAN WKE007 Mode D'emploi

Chauffe-cire
Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

CONTENT
On arrival of the package, check the pre-
sence of the following items:
- Wax heater
OPERATION
1.
Put the wax into the inner housing
and connect the machine to the power.
2.
Please read this document carefu-
lly before using the device. Keep it in an
accessible place so that you can read it
at any time.
3.
When the indicator light turns into
green, the machine starts heating.
4.
Then, adjust the temperature ac-
cordingly to the patient comfort.
5.
Before starting to remove the hair,
clean the grease and cosmetic that may
remain on the skin with cotton that has
been previously soaked in an astringent
lotion. You can also use a toilet powder
that absorbs moisture and grease. This
will make the hair adhere to the wax
more easily.
6.
Daub the soft wax following the
direction the hair growth.
7.
After being heated, the wax should
be applied with a wooden spatula on the
skin to be treated. The thinner the wax
layer is, the easier the hair removal beco-
mes.
8.
Do not surpass the paper band
surface.
9.
Hold with one hand the paper
band tightly, and use the other to press it
against the skin.
EN
10.
Pull the paper band quickly in the
opposite direction the hair growth.
11.
After use, apply some smoothing
lotion to clean the skin.
REMARKS AND RECCOMEN-
DATIONS
• Do not pour the wax after treatment
if it is still liquid. Turn the machine off
first and let the wax cool down. Turn it on
again and when the wax starts melting at
the bottom, the wax block will be easier
to remove.
• Do not turn the machine on when the
pot is empty.
• When you add wax, move or clean the
machine, turn it off.
• Do not directly touch the pot with your
hands. Take it out with the provided tool
to avoid getting burnt.
• This device is intended for professional
use.
• Use alcohols or other wax removal lo-
tions to clean the machine.
• Turn the machine off before cleaning it.
• Do not move the machine when it is
heating or when the wax temperature is
too high. The temperature may reach the
115ºC while working.
• Do not spill the wax. Clean it up if it
gets accidentally spilt, otherwise it will
become difficult to remove it.
• If the power cord is damaged, get the
component at the manufacturer or at an
authorised technical service.
• Do not use it on damaged or sensitive
areas of the skin.
• Do not pour the used wax into the outer
pot of the machine.

TECHNICAL SPECIFICATIONS

CAPACITY
RATED POWER
RATED VOLTAGE
750 ML
380w
AC 220V ~ 240V
© 2020 Weelko
www.weelko.com
Importer: Weelko Barcelona, S.L.
ESB65397556

Publicité

Table des Matières
loading

Table des Matières