Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
11) PRIORITY CHANNELS
Priority channels will be automatically
3 positions switch: EMG1/ Priority channel 1 is activated. EMG2 / Priority
channel 2 is activated. OFF / No priority channel is activated.
The default priority channels are channel 9/AM/band A (EMG1) and chan-
nel 19/AM/band A (EMG2).
See the EMG SET 1 and EMG SET 2 menus page 26 to
Note: Activating a priority channel no longer allows you to change modula-
tion mode (AM or FM), to start the SCAN function or activate the
If the KEY BEEP function is active, an error beep is emitted. "EMG" and the
channel blink to indicate unauthorized handling. Turn the switch (11) to the
OFF position to use these functions.
12) ECHO
Allows to
enable/disable
ECHO function.
See menu ECHO SET page 28 for ECHO configuration.
13) MODE ~ PA
MODE
(short press)
Press MODE key (13) to
select
mode is displayed on display.
Your modulation mode has to correspond to the one of your correspondent.
-
Frequency Modulation / FM: for nearby communications on a flat open
field.
Amplitude Modulation / AM: communication on a field with relief and
-
obstacles at middle distance (the most used).
PA
(long press)
PA
Switch between normal and
An external optional speaker can be connected to the unit to the PA.SP.
jack on the rear panel. (D). Turn the MIC GAIN knob (4) to adjust the
volume.
PA
For details on operating in
27.
selected
by switching this key (11).
set
priority channels.
PA
the modulation mode: AM or FM. Selected
(Public Address) mode.
mode, see the PA SETTING menu on page
14) BARGRAPH
Indicates
the reception level and the emitted power level.
15) 6 PIN MICROPHONE PLUG
mode.
The plug is located on the front panel of the transceiver and makes the
setting of the equipment into the dashboard easier.
See Cabling Diagram page 74.
16) USB CHARGING SOCKET
The USB socket (16) can be used to charge smartphones, tablets or other
rechargeable devices with 5 V - 2.1 A.
17) PTT
Transmission key, press to
to
listen to
an incoming communication,
TOT (Time Out Timer)
If the PTT switch (17) key is pressed for more than 5 minutes, the display starts
blinking and the transmission ends. A beep will sound until the PTT switch
(17) key is released.
18) UP/DN BUTTONS ON MICROPHONE ~ SCAN
UP/DN BUTTONS ON MICROPHONE
In normal use, press UP/DN buttons (18) on the microphone to
frequency. UP to
increase
PA
In MENU mode [press the PUSH knob (6) for about 3 seconds to activate this
mode (see § MENU page 25)], the UP or DN buttons (18) allow to
the menu to be set.
See ROTARY "PUSH" KNOB page 22.
24
transmit
a message,
is displayed and release
disappears.
(short press)
and DN to
decrease
the frequency.
change
the
select
Publicité
Table des Matières
