Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
TR145
Installation Procedure for the individual Vehicle Model
Manufacturer
BMW
Vehicle preparations
→
Outside of vehicle
Roof
Fig-1
Carrier installation locations
Protection sheet
Nut of the vehicle
Vehicle model
Vehicle type
3 Series
Cover
Model year
Sedan
2012 -
Cleaning the installation area on the
vehicle
Wipe dirt and oil off the roof and
moldings using diluted mild detergent,
and then dry the wiped area.
*Shaded area in the figure.
●Do not use organic solvents such as thinner or benzene to
clean dirt and oil.
Lifting the cover of the carrier
installation locations
3
Applying the protection sheets
Apply the protection sheets to the area of
roof molding on the roof. Apply each
protection sheet aligning its center to the
nut on the vehicle as shown in the figure
(see Fig-1), and also place one edge
of the protection sheet along with the end
of radius curve on the roof molding
(see Fig-2).
Fig-2
End of radius curve
Protection sheet
Roof molding
EN-4
Loading conditions
Maximum
Load Capacity
140
lbs
(
kg)
64
( Load + Base rack
+ Attachments )
Protection sheet
4182808TR1454
EN
Bike
3
-A
-EN
Publicité
Table des Matières
