Installation - IFM Electronic Efector 300 SA3010 Notice Utilisateur

Display mode
(Indication of parameters and the set parameter values)
When the "Mode/Enter" button is pressed briefly, the unit passes to
the Display mode which allows parameter values to be read. The inter-
nal sensing, processing and output functions of the unit continue as if
in Run mode.
• The parameter names are scrolled with each pressing of the
"Mode/Enter" button.
• When the "Set" button is pressed briefly, the corresponding para-
meter value is displayed for 15 s. After another 15 s the unit returns
to the Run mode.
Programming mode
(Setting of the parameter values)
While viewing a parameter value pressing the "Set" button for more
than 5 s causes the unit to enter the programming mode. You can
alter the parameter value by pressing the "Set" button and confirm
the new value by pressing the "Mode/Enter" button. The internal
sensing, processing and output functions of the unit continue as if in
Run mode with the original parameter values unless a new value is
confirmed. The unit returns to the Run mode when no button has
been pressed for 15 s.

Installation

Step 1
Grease the nut (A) with greasing
paste to ensure the nut can be
loosened and tightened several
times. Note: No grease must be
applied to the sensor tip.
Remove the protective cap (B)
from the sensor tip. Insert the
unit into the T-piece.
grease
A B
25