Before First Use - Klarstein EISPALAST Mode D'emploi

EN
18

BEFORE FIRST USE

• Before use, remove all packing materials, including bottom cushions, foam pads
and tapes inside of the freezer; tear off the protective film on the doors and the
freezer body.
• Keep away from heat and avoid direct sunlight. Do not place the freezer in moist or
watery places to prevent rust or reduction of insulating effect.
• Do not spray or wash the freezer; do not put the freezer in moist places easy to
be splashed with water so as not to affect the electrical insulation properties of the
freezer.
• The freezer is placed in a well-ventilated indoor place; the ground shall be flat, and
sturdy.
• The top space of the freezer shall be greater than 70 cm, and The freezer should
be placed against a wall with a free distance more than 20 cm to facilitate heat
dissipation.
OPERATION
Note: The green lamp is the power indicator. The lamp lights up when the unit is
switched on.
Setting the temperature
The storage temperature can be set via the thermostat. . The temperature can be adjusted
by turning the thermostat from [1] to [7]. Turn the thermostat counterclockwise to lower
the temperature in summer. Turn the thermostat clockwise to increase the temperature in
winter.
Test run and commissioning
Insert the plug into the socket and wait. A significant drop in temperature within half
an hour indicates that the freezer is functioning properly. Let the appliance run for a
certain period of time (6 hours in summer, 4 hours in winter) before storing food in the
appliance.