System Assembling - Optika Italy TB-3W Manuel D'instructions

7.2

System assembling

1. Remove the dust cover from camera and from
projection lens.
2. Screw the projection lens to the camera's thread.
(Fig. 1)
3. Insert the final part of the projection lens into the
empty hole of the photo/tv exit. (Fig. 2)
4. Mount the tablet. Insert the connectors ① placed
on the camera bracket into the holes ② placed
on the tablet bracket and gently push down until
the connectors are properly locked. (Fig. 3-4-5)
• You can select one of three sets of holes to
position the tablet at the desired height.
• To remove the tablet from the bracket, gently push
up and pull the connectors out of the bracket.
Install the tablet.
Page 6
②
①
Fig. 1
Fig. 2
Fig. 3
Fig. 4