Installation; General Operating Instructions; Prepare The Remote Control - Telestar DIRA M 14i Manuel D'utilisation

6. INSTALLATION

6.1 General operating instructions

> Switch the device on or off with the standby button on the
remote control.
> Increase the volume with the VOL+
button on the remote control.
> Reduce the volume with the VOL- button on the remote control.
> The menu items can be accessed using the ▼ ▲ buttons.
> You can confirm a selection with the ENTER button.

6.2. Prepare the remote control

Remove the battery transport lock on the remote control. To do
this, pull out the plastic tab on the battery housing of the remote
control. This establishes the battery contact.
To replace the remote control battery, open the battery compart-
ment on the back of the remote control.
Pull the battery compartment out of the remote control.
Remove the battery and insert a new battery of the same type.
There is a risk of explosion if batteries are used improperly!
Read the safety instructions in chapter 2.8 on this.
Pay attention to the correct polarity of the battery!
Then insert the battery compartment again.
110
EN