Senix CS4QL-L1 Manuel D'instructions page 17

WARNING
If the saw chain fails to stop when the chain brake is
engaged, take the product to the nearest authorized
service center or a similarly qualified person! Do not
use the product if the chain brake is not in working
properly!
WARNING
The front hand guard can only be used for short time
check and emergency. It should not be used for starting
and stopping the product during normal operation!
Otherwise the clutch and/or the clutch cover will be
damaged!
Chain speed
The saw chain shall not move under engine idle speed
without pressing the throttle trigger.
WARNING
If the saw chain shows any sign of moving, stop the
engine immediately! Wait for all moving parts to stop!
Contact an authorized service center or a similarly
qualified person to readjust idling speed!
Checking chain lubrication
The chain lubrication should be checked after
everything else is ready before cutting.
This product is equipped with an automatic oiling
system! The oiling system automatically delivers the
proper amount of oil to the bar and chain.
Start the engine; keep it running at medium speed
and check if the chain oil is delivered as shown in the
figure(Fig.17).
WWW.SENIXTOOLS.COM
Fig. 17
Cutting procedure
1. To become proficient attend a recognised chain saw
training course to learn how to operate chain saws
safely and effectively. Familiarise yourself with all
the controls and switches. Practice all movements
with the product switched off.
2. Always hold the product firmly with both hands.
Front handle with the left hand and rear handle with
the right hand. Fully grip both handles at all times
during operation. Never operate the product using
only one hand.
3. Only use the product with a secure stance. Hold the
product at the right-hand side of your body(Fig.18).
4. Ensure that cutting object does not exceed the
usable cutting length of the chain saw. The tip of
guide bar shall always be kept at least 1.97in.(5 cm)
outside the outline of the wood log.
5. Ensure the saw chain is running at full speed before
it makes contact with the wood. Use the spiked
bumper to secure the product onto the wood before
starting to cut and use it as a leverage point while
cutting(Fig.19).
Fig. 18
Fig. 19
17