Manual Operations - Duramaxx 10027579 Mode D'emploi

How to copy Program settings
For a new day program setting, you can use Copy feature to set this day program same as the one
just set.
• At the beginning of a day program setting, press HOLD button. The
COPY symbol fl ash on the display. Press OK button for confi rm it. And
back to above procedure to select next day program for setting.
• Repeat procedure B and C to fi nish all the day program setting.
• Press OK button to save quit this setting.
Before overriding the status press the UNIT button fi rst to select the Unit number of Actuator to be
programmed. The Actuator Unit number shown the right bottom corner of LCD display. Unit "A" for
all the unit.
Manual Overriding the current Program Temperature Status
• Press TEMP button to override diff erent temperature status. This over-
riding will be continued to the next hour. The Temporary Manual Control
symbol appears on the display.
Manual Temperature Setting Override
• Turn the setting dial to adjust the current temperature setting. This overriding will be continued to
the next hour. The Temporary Manual Control symbol appears on the display.
Temporary Hold the current temperature setting
• Press and hold the HOLD button for 3 seconds to enter. Turn the setting
dial to set the holding time from 1 to 99 hours.
• Press OK button to save and quit this setting. The Temporary HOLD
symbol appears on the display.
Manual AUTO/OFF/Anti-Frozen setting
• Press and hold the MANUAL button for 3 seconds to enter.
• Press SELECT button to select one of the following and then press OK button to save and quit this
setting.
a. AU-Auto, program control mode.
b. AF-Anti-Frozen.
c. oF-OFF, system turn OFF

Manual Operations

12