Invion GPS-5V1 Manuel D'instructions page 38

When in the Stops screen, you can use the following commands:
Stops Actions
You can tap the Actions button for the following command options:
Set as Origin Lets you designate the selected address as the route origin. You
would use this command when calculating a route from a point
other than your current location. Note: You are still connected to
the GPS signal.
Add Stop Lets you add a location by specifying an address from recent
locations, favorite locations, or pre-defined POIs, such as gas,
food, or lodging.
Rename Stop Lets you change the stop information, such as name, comments,
or route group.
Delete Stop Lets you remove a selected stop.
Optimize Your trip itinerary is created by the sequence of stops entered.
Route This may not be the most efficient route. When you click Optimize
Stops, the software changes the order of stops to create the most
efficient route.
Information
This button displays the location's address information.
Use the Up or Down buttons to change the order of your
itinerary.
Shows the stop destination on the map and lets you select
a route type, Quick or Short. Tap Go to calculate the stop
destination.
Select the Show button to view the selected stop destination
on the map.
8