Mounting Accessories - IFM LK81 Manuel De L'utilisateur

• For mounting in plastic pipes / plastic tanks the inside (pipe) diameter
must be min. 12 cm (4.8 inch).
• For mounting in metal pipes the inside pipe diameter must be at
least:
Diameter
Marking of the installation height:
Fix the set installation height
with the supplied stainless steel
tube clip. If the sensor is
removed from the fixture for
maintenance the clip serves as a
limit stop when remounting the
sensor. Thus an inadvertent mal-
adjustment of the sensor is
excluded.
This is in particular necessary for the correct function of the over-
flow protection.
The clip is fitted using common nipper pliers. Ensure a correct fit. To
remove the clip, it must be destroyed.

Mounting accessories:

Mounting clamp Ø 16 mm, PP (polypropylene) .................. order no. E43000
Flange plate 73 - 90, aluminum / stainless steel ................. order no. E43001
Welding bush, stainless steel .............................................. order no. E43002
Mounting adapter G3/4", stainless steel.............................. order no. E43003
Mounting adapter G1", stainless steel................................. order no. E43004
Flange plate 100 - 125, aluminum / stainless steel ............. order no. E43005
Flange plate 65 - 80, aluminum / stainless steel ................. order no. E43006
Flange plate 54 - 52 x 52, aluminum / stainless steel .......... order no. E43007
Mounting set Ø 16 mm, PP (polypropylene) / steel .............. order no. E43016
30
MEDI = CLW1
cm inch
4.0 1.6
MEDI = CLW2, OIL1
cm inch
6.0 2.4
MEDI = OIL2
cm inch
12.0 4.8