Samsung NX60-8 Série Mode D'emploi page 25

To adjust flame low setting
Identify which burner is exhibiting too high or too low of simmer rate via manifold
panel graphics.
Simmer Set
Screw
Small
Screwdriver
Valve Stem
WARNING
1. Do not completely remove the valve set screw from the valve stem. The valve
set screw is an integral part of the gas valve assembly. Removing the valve set
screw will cause gas to leak.
2. After adjusting the valve set screw, inspect the assembly for gas leaks.
Install_NX60T9700_BEST_BETTER_AA_DG68-01243A-00_EN.indd 25
1. Rotate a knob to LO position and remove
the knob from the valve stem while the
flame is lit.
2. Carefully push the screw driver into the
stem of the valve, until it hits the simmer
set screw. Make sure the screwdriver
flathead is seated into the set screw
groove.
3. Rotate valve set screw clockwise to
decrease LO setting flame output, or
rotate set screw counter clockwise to
increase LO setting flame output.
Memo
English 25
2020-03-26 6:41:26