ecolight UC1040-BR2-14LF4-E Mode D'emploi

Rampe d'eclairage a del convertible a installer sous une armoire

Publicité

Les langues disponibles

Les langues disponibles

Liens rapides

LED CONVERTIBLE UNDER CABINET BAR
RAMPE D'ÉCLAIRAGE À DEL CONVERTIBLE
À INSTALLER SOUS UNE ARMOIRE
BARRA CONVERTIBLE CON LED
PARA DEBAJO DEL GABINETE
To Begin/Pour commencer/Para comenzar
WARNING: Please read this entire manual before installation.
Verify the following contents:
AVERTISSEMENT : Veuillez lire ce mode d'emploi du début à la fin avant
de commencer l'installation. Vérifiez le contenu suivant :
ADVERTENCIA: Por favor, lea este manual completo antes de realizar la
instalación. Verifique el siguiente contenido:
Switch
Interrupteur
Interruptor
Hardware Kit (Actual hardware may differ from illustration).
Trousse de quincaillerie (La quincaillerie incluse peut être différente de l'illustration.)
Kit de aditamentos (Los aditamentos reales pueden diferir de los que se muestran en la ilustración.)
Required/Nécessaire/Se necesita
Installation time: 45 minutes
Temps d'installation : 45 minutes
Tiempo de instalación: 45 minutos
English
Warnings and Cautions
WARNING
• Shut off power at the circuit breaker or fuse panel before removing the
old fixture or installing the new one.
• LEDs can be damaged by electrostatic discharge (ESD) shock. Before
installation, discharge yourself by touching a grounded bare metal
surface to remove this hazard. To avoid damage, do not remove the
clear lens over the LED module.
CAUTION
• This device complies with Part 15 of the FCC rules. Operation is subject
to the following two conditions: (1) This device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
Wire coupling
Coupleur de fils
Acoplamiento
de cable
Safety glasses
Lunettes de sécurité
Gafas de seguridad
Phillips screwdriver
Tournevis cruciforme
Destornillador Phillips
Flathead screwdriver
Tournevis à tête plate
Destornillador de cabeza plana
Wire cutters
Coupe-fil
Pinzas cortacables
(Página 8)
Diffuser
Diffuseur
Difusor
Linking cord
Cordon de
raccordement
Cable de conexión
- 1 -
Model/Model/Modelo #:
UC1040-BR2-14LF4-E,
UC1040-BR2-22LF6-E
(Page 1)
(Page 4)
Power cord
Cordon d'alimentation
Cable de alimentación
Electrical tape
Ruban isolant
Cinta aislante
Drill bits 1/16 in.
Forets de 1/16 po
Brocas para taladro de 1/16 pulg
Drill
Perceuse
Taladro
Pliers
Pinces
Pinzas
Wire strippers
Pinces à dénuder
Pinzas pelacables

Publicité

Table des Matières
loading

Sommaire des Matières pour ecolight UC1040-BR2-14LF4-E

  • Page 1 Model/Model/Modelo #: UC1040-BR2-14LF4-E, UC1040-BR2-22LF6-E LED CONVERTIBLE UNDER CABINET BAR (Page 1) RAMPE D’ÉCLAIRAGE À DEL CONVERTIBLE À INSTALLER SOUS UNE ARMOIRE (Page 4) BARRA CONVERTIBLE CON LED PARA DEBAJO DEL GABINETE (Página 8) To Begin/Pour commencer/Para comenzar WARNING: Please read this entire manual before installation.
  • Page 2: Important Safety Instructions

    Important Safety Instructions This unit has a polarized plug (one blade is wider than the other) as a safety feature. This plug will only fit in a polarized outlet one way. If the plug does not fit completely into the outlet, reverse the plug.
  • Page 3 Once the screws are removed place the cover aside to expose the wire compartment and the captive mounting screws (Fig. 2). These will be located on both ends of the Fig. 2 wire compartment. Determine which corresponding knock-out is closest to the supply Fig.
  • Page 4: Troubleshooting Guide

    This warranty gives you specific rights, and you may also have other rights which vary from state to state. Ecolight™ 5260 Capitol Drive, Wheeling, IL 60090 Printed in China Français...
  • Page 5: Instructions Pour Le Gradateur

    AVERTISSEMENT : Afin de réduire les risques d’INCENDIE, DE CHOC ÉLECTRIQUE OU DE BLESSURE : 1. Pour USAGE À L’INTÉRIEUR SEULEMENT. 2. Ne touchez PAS aux ampoules à DEL. 3. Ne retirez PAS la lentille protectrice transparente des ampoules à DEL. 4.
  • Page 6: Installation À Raccordement Direct

    Installation à raccordement direct Coupez l’alimentation électrique au coffret de branchement, puis retirez l’ancien luminaire. S’il est doté de plus de deux fils de connexion, utilisez des repères pour déterminer quels fils étaient raccordés ensemble. AVERTISSEMENT : JETEZ LE CORDON D’ALIMENTATION pour éviter toute situation dangereuse. Le luminaire est muni de vis de montage imperdables Fig.
  • Page 7: Instructions De Raccordement

    Cette garantie vous confère des droits précis. Il est possible que vous disposiez également d’autres droits, qui varient d’un État ou d’une province à l’autre. Ecolight™ 5260 Capitol Drive,Wheeling, IL 60090 Imprimé en Chine - 7 -...
  • Page 8: Advertencias Y Precauciones

    Español Advertencias y precauciones ADVERTENCIA • Antes de extraer la lámpara antigua o instalar la nueva, corte la alimentación en el interruptor de circuito o el panel de fusibles. • Los LED pueden dañarse por una descarga electrostática (ESD, por sus siglas en inglés).
  • Page 9 Use un destornillador de cabeza plana y retire con Fig. 5 cuidado la tapa plástica que cubre el puerto de alimentación en la lámpara (Fig. 5). ADVERTENCIA: Antes de completar la instalación, NO enchufe Fig. 6 el cable de alimentación al suministro de electricidad. El cable de alimentación tiene en un extremo un enchufe tradicional conectado a tierra y en el otro extremo, un enchufe del conector del cable.
  • Page 10: Guía De Solución De Problemas

    Esta garantía le otorga derechos específicos, pero podría tener también otros derechos que varían según el estado. Ecolight™ 5260 Capitol Drive, Wheeling, IL 60090 Impreso en China ©2014 Ecolight™...

Ce manuel est également adapté pour:

Uc1040-br2-22lf6-e

Table des Matières