Team kalorik GBBQ 1004 Mode D'emploi page 17

Troubleshooting:
Problem
Grease fire or
continuous
excessive flames
above cooking
surface
Burner will not light
using ignitor
Possible cause
Too much grease
buildup in burner area
Gas issues
1.Trying to light wrong
burner
2. Burner not engaged
with control valve
3. Obstruction in burner
4.No gas flow
5.Vapor lock at coupling
nut to LPtank
6. Coupling nut ad LP
tank valve not fully
connected.
Prevention/ Solution
Turn off LP Tank. Leave lid open to allow flames
to die down. After cooling, clean food particles
and excess grease from inside firebox area,
grease cup/pan/tray, and other surfaces
1. See instructions on control panel and section
in the Use and Care.
2. Make sure valve are positioned inside of
burner tubes.
3. Ensure burner tubes are not obstructed with
spider webs or other matted, see cleaning
section of use and care
4.Make sure LP tank is not empty. If LP tank is not
empty, refer to "sudden drop in gas flow.
5.Turn off knobs and disconnect coupling nut
from LP tank. Reconnect and retry.
6. Turn the coupling nut approximately one-half
to three-quarters
17
GBBQ 1004
- 190108