Team kalorik GBBQ 1004 Mode D'emploi page 12

INSTALLATION
After purchasing your gas cylinder you will then be ready to set it up with your gas grill.
When changing the gas cylinder which shall be carried out away from any source of ignition.
Position the gas cylinder at left side of your gas grill, should not be placed inside BBQ, keeping
in mind that the bottle must be kept away from heat and in a safe position.
When ready to use your gas grill insert the regulator into the gas bottle valve and tighten firmly.
Warning: Before attempting to light your gas grill you must refer to your lighting instructions and
warning / safety points.
Check the hose before each use, searching for cracking, cuts or any abrasions. If the hose is
found to be faulty in any way do not attempt to use your gas grill.
When changing your gas bottle ensures that there are no sources of ignition close by i.e. fires,
cigarettes, naked flames etc. Make sure that the appliance is switched off.
Ensure that the hose is not subjected to twisting which will affect the gas flow when installing
your gas grill. Also the hose must not have undue tension and must not touch any part of the
gas grill which may be hot.
Please choose flexible hose whose heatproof higher than 80℃
Flexible tube should be changed every 2 years; It's necessary to change the flexible tube
when the national conditions require it.
HOW TO CHANGE YOUR CYLINDER
Note: Turn off the switch of cylinder (No spanner is required)
The height of the gas cylinder is below the 80cm, and the width is within 35cm
How to connect a gas bottle
Turn the orange cap so that the arrow is pointing to the gap in the shroud.
Remove the orange safety cap by pulling the lanyard out, then out. Do not use tools. Leave
the cap hanging.
Check that the black sealing washer is fitted inside the cylinder valve. Connect the regulator to
the valve.
Turn the switch clockwise on gas bottle-then turn on the gas grill as instructed.
Gas connector Hose
Gas cylinder
Hose
Regulator
Warning: Always test gas line for leaks at connector with soap water finishing all connections.
12
GBBQ 1004
- 190108