Makita DTW1001 Manuel D'instructions page 8

Changing the impact force
► Fig.8: 1. Changed in three steps 2. Hard 3. Medium
4. Soft 5. Button
You can change the impact in three steps: hard, medium and soft mode.
This allows a tightening suitable to the work.
Every time the button
For approximately one minute after releasing the switch trigger, the impact force can be changed.
Specifications of each impact force grade
Impact force grade displayed on
panel
Hard
Medium
Soft
Impact force/bolt size corresponding chart (reference)
Impact force grade displayed on
panel
Hard
Medium
Soft
is pressed, the number of blows changes in three steps.
Maximum blows
DTW1001 / DTW1002 /
DTW1001XV DTW1002XV
2,200 min
2,000 min
1,800 min
DTW1001 / DTW1001XV
Standard bolt High tensile
M20 - M30 M16 - M24
(3/4" - 1-1/4")
M16 - M24 M12 - M20
(5/8" - 1") (1/2" - 3/4")
M12 - M20 M10 - M16
(1/2" - 3/4") (3/8" - 5/8")
DTW800 /
DTW800XV
-1
(/min) Tightening when force and speed are desired.
-1
(/min) Tightening when you need good controlled power.
-1
(/min) Tightening when you need fine adjustment with
small diameter bolt.
DTW1002 / DTW1002XV
Standard bolt
bolt
M20 - M30
(5/8" - 1") (3/4" - 1-1/4")
M16 - M24
(5/8" - 1")
M12 - M20
(1/2" - 3/4")
8 ENGLISH
Application
DTW800 / DTW800XV
High tensile Standard bolt
bolt
M16 - M24 M20 - M24
(5/8" - 1") (3/4" - 1")
M12 - M20 M14 - M20
(1/2" - 3/4") (9/16" - 3/4")
M10 - M16 M12 - M16
(3/8" - 5/8") (1/2" - 5/8")
High tensile
bolt
M16 - M22
(5/8" - 7/8")
M10 - M16
(3/8" - 5/8")
M10 - M12
(3/8" - 1/2")