Brushing Modes - Philips Sonicare FlexCare Platinum HX9112/02 Mode D'emploi

4 Apply light pressure to maximise Sonicare's
effectiveness and let the Sonicare toothbrush
do the brushing for you. Do not scrub.
5 Gently move the brush head slowly across
the teeth in a small back and forth motion
so the longer bristles reach between your
teeth. Continue this motion throughout
your brushing cycle.
Note: To make sure you brush evenly throughout the
mouth, divide your mouth into 4 sections using the
Quadpacer feature (see chapter 'Features').
6 Brush each section for 30 seconds for a total
brushing time of 2 minutes. Start with section
1 (outside top teeth) and then brush section
2 (inside top teeth). Continue with section
3 (outside bottom teeth) and finally brush
section 4 (inside bottom teeth).
Note: After you have completed the brushing cycle, you
can spend additional time brushing the chewing
surfaces of your teeth and areas where staining occurs.
You may also brush your tongue, with the toothbrush
switched on or off, as you prefer.
The Sonicare is safe to use on:
- Braces (brush heads may wear out more quickly
when used on braces)
- Dental restorations (fillings, crowns, veneers,
implants)

Brushing modes

Clean: The ultimate in plaque removal (default
1
mode).
White: 2 minutes to remove surface stains and
2
30 seconds to brighten and polish your front
teeth.
ENGLISH
9