Two Way Intercom - Philips SBC SC477 DECT Instructions Pour L'utilisation

ENGLISH
10
LEVEL
SYSTEM
POWER
LEVEL
SYSTEM
POWER
SYSTEM

Two way intercom

Your SBC SC477 is suited for use as a two-way intercom.
1 Set the MONITOR / INTERCOM power on switch (8) on the Baby Unit
to INTERCOM.
> The DECT system check light blinks (green).
2 Switch on the Parent Unit by pressing the POWER button.
3 Wait for an established connection (system check lights green).
4 Adjust the loudspeaker volume level of the Baby Unit to a level you prefer.
5 Adjust the loudspeaker volume level of the Parent Unit to a level you
prefer.
6 On the Parent Unit, press and hold the TALK button (15) and talk clearly
into the microphone.
Note: Wait with talking until the system check light is blinking green.
Note: In case the TALK button is pressed on the Parent Unit, and the
loudspeaker volume of the Baby Unit is set to 0, the system check lights
will light red.
Note: In case the TALK button is pressed on the Baby Unit, and the loudspeaker
volume of the Parent Unit is set to 0, the Parent Unit will beep to indicate
this.
7 Release the TALK button (15) when you are finished.
8 On the Baby Unit, press and hold the TALK (3) button and talk clearly
into the microphone.
9 Release the TALK (3) button when you are finished.
While the TALK button on either unit is being pressed, a signal from the
other unit cannot be heard. In other words,only one person should speak
at a time.